Who We Supply
Architectural and Facade Lighting Contractors
Contractors lighting building facades, coves and linear detail, where the run is long, the access is expensive and the light has to read as a line rather than a row of dots.
Where It Goes Wrong
- A cove lit with discrete LEDs that dots in the ceiling reflection.
- A low-voltage run so long that the far end is visibly dimmer.
- A driver every few metres in a position nobody can reach again.
- Strip cut between segments, killing the last section.
- Colour control specified after the strip has already been bought.
What These Buyers Ask For
- Dot-free output for coves and reveals
- A mains-voltage option for long runs
- Published cut lengths before the detail is designed
- High colour rendering where finishes have to look right
- Addressable control where the facade has to change
Recommended Products
The Products That Apply Here
RB0Z0WW08A
COB LED Strip, CCT Series, 640 LEDs/m
Dot-free COB strip at 640 LEDs/m, 24 V, 800 lm/m, Ra > 90, cut every 25 mm.
See the specification
RCC60AF12Z-1225-DMX512
DMX512 Neon Flex Strip, 60 LEDs/m
DMX512-addressable RGBW neon flex, 60 LEDs/m, 24 V, 450 lm/m, cut every 100 mm, 5 m per roll.
See the specification
R7C0GX10I
2835 LED Strip, High Voltage Series, 120 LEDs/m
220 V mains strip at 120 LEDs/m, 1440 lm/m and 120 lm/W, cut every 100 mm.
See the specification
R060AH10Q (12 V) / R060AH10R (24 V)
5050 LED Strip, Colorful Series, RGBW 60 LEDs/m
SMD5050 RGBW strip at 60 LEDs/m, 17.2 W/m, available in a 12 V and a 24 V model with different cut lengths.
See the specificationTypical Scenarios
- Illuminated coves and ceiling reveals
- Facade lines and building outlines
- Pixel-mapped feature lighting using DMX512 neon flex
- Under-counter and display lighting in retail interiors
How We Supply
- Cut lengths published per product so the detail can be drawn around them
- 220 V high-voltage strip where a driver would be unserviceable
- Ra > 90 on the COB CCT series where finishes matter
- DMX512 control on the neon flex product
Installed
Photographs From This Kind Of Site
Guides For This Kind Of Buyer
Questions
Architectural and Facade Lighting Contractors Questions
Which product gives a genuinely continuous line?
The COB CCT series, at 640 LEDs per metre under a single phosphor line.
How do I avoid a driver in an unreachable position?
The 2835 high-voltage series runs from 220 V, so the rectification happens at the supply end rather than along the run.
Can the facade be pixel mapped?
The DMX512 neon flex is the product for that. It publishes a 100 mm cut length, 60 LEDs per metre and 24 V input.
Talk Through A Scheme
Send the positions, the mounting available and the quantity. A shortlist with specifications comes back by email.