SIC Silicon Carbide Ceramic Ring Cylinder
Silicon carbide rings and cylinders held to ±0.005mm.
- ShapeCustom
- SizeCustom
- ApplicationIndustry ceramic
Petroleum And Chemical
Wetted parts that survive chemistry which eats stainless steel.
Industry Pain Points
- Acid and alkali attack metal wetted parts and contaminate the process stream.
- Abrasive catalyst and sand wear a metering surface out of tolerance.
- Downtime to change a wear part costs more than the part itself.
What Buyers Ask For
- Alumina and zirconia parts that are insoluble in water and only slightly soluble in strong acid and alkaline solutions.
- Silicon carbide rings and cylinders for the most abrasive duty.
- Rods, tubes and rings made to your drawing rather than a catalogue size.
Suitable Products
Refractory Alumina Ceramic Tube
Furnace work tubes and thermocouple protection tubes rated to 1650°C.
- ColorWhite, pink
- Density3.85 g/cm3
- MONS' HardnessGrade 9
Zirconia Ceramic Rod
Centreless ground zirconia rod, custom size and colour, low MOQ.
- MaterialZirconia
- FeaturesHigh hardness, high strength, high temperature
- SizeCustomized
99% 95% Al2O3 Alumina Ceramic Ring
Dense alumina rings for pump seals, insulators and wear seats, in 95% and 99% grades.
- MaterialAlumina ceramic
- SizeCustomized
- ShapeRing
How The Job Runs
From the first drawing to a repeat order, with the terms stated up front.
- EnquirySend the drawing, the quantity and the duty.
- Material CallWe confirm which family fits and why.
- Free Sample4 to 7 working days, freight paid by the buyer.
- Production15 to 30 days with an inspection report.
Materials Used Here
SSIC And SIC Parts
Silicon carbide rings, cylinders and seal faces for abrasive slurry and hot gas duty where alumina wears through too quickly.
See the range
Al2O3 Alumina Ceramic Parts
95% and 99% alumina rings, tubes, substrates and plates for insulation, wear and high temperature service up to 1650C.
See the range
Zirconia Ceramic Parts
High toughness zirconia parts for wear surfaces that run against metal, fluid or fibre without picking up magnetism or corroding.
See the rangeRelated Reading
- Zirconia Or Alumina Which To SpecifyToughness against hardness, cost and temperature
- Alumina 95% Or 99% PurityWhat the extra four percent changes
- Silicon Nitride And Silicon Carbide ComparedTwo hard ceramics with different jobs
- How A Ceramic Part Is MadePowder to finished part, step by step
Related Services
- Custom Ceramic Parts To DrawingOEM and ODM from your drawing, sample to volume
- Precision Grinding And PolishingFlat processing, precision processing and polishing
- Metallizing And BrazingMo/Mn metallizing with Ni, Cu, Ag or Au plating
- Laser Machining For SubstratesCutting, drilling, scribing and marking
Questions From This Sector
Do you have a standard part for this application?
Some, and they are listed on this page. Most of what we ship for this sector is made to a customer drawing.
Can we trial a small quantity first?
Yes. Samples are free of charge with freight paid by the buyer, and take 4 to 7 working days.
What lead time should we plan for production?
15 to 30 days if the goods are not in stock, according to the dimension and quantity.
Will you inspect against our drawing?
We inspect according to your drawings and issue an inspection report.
Talk To An Engineer About Petroleum And Chemical
Send the drawing or describe the position the part sits in.