Knowledge Center
Tire Inflator Use Guide
The operating sequences printed on our colour boxes, in one page. Send this to your customer service team or reuse it in your own listing.
12 Volt Models That Plug Into The Car Socket
This sequence applies to the mechanical gauge models, the digital gauge models and the tyre repair kits.
Standard Operating Instructions
- 1
Start the car engine before using.
- 2
Insert the car plug of the compressor into the car socket.
- 3
Connect the nozzle of the compressor to the nozzle of the tyre. Be careful that the fitting must be tight enough.
- 4
Open the power switch. Inflate according to the tyre pressure values (210~250 kPa / 2.1~2.5 bar / 30~35 psi). Then turn the power off and back out the nozzle from the tyre and pack it for next use.
Models With Preset Pressure
This sequence applies to the preset digital gauge models, which stop automatically once the tyre reaches the pressure you set.
Preset Pressure Operating Instructions
- 1
Pull out the air pipe before using.
- 2
Preset the air pressure for your car motorcycle bicycle or basketball.
- 3
Connect the nozzle of the tire inflator to the nozzle of the tire. Be careful that the fitting must be tight enough.
- 4
Press the power switch. It starts to inflate and stops automatically after the tire reaches the preset air pressure (210~250 kPa / 2.1~2.5 bar / 30~35 psi).
- 5
Back out the nozzle from the tire and pack it for next time use.
Reference Values
| Car tyre pressure range on our packaging | 210~250 kPa / 2.1~2.5 bar / 30~35 psi |
|---|---|
| Maximum pressure of the inflator range | 120 psi |
| Reference tyre used for inflate time | Flat standard tyre 195/65R15 to 35 psi |
| Power cable length | 3000±100 mm |
| Operation temperature | -20~60 ºC |
| Sealant supplied with the repair kits | 430 ml, for punctures under 6.5 mm diameter on tubeless tyres |
Always follow the tyre pressure specified by the vehicle manufacturer.
Use Guide FAQ
Do I Need The Engine Running
For the 12 volt models that plug into the car socket, start the car engine before use.
What Pressure Should A Car Tyre Be
The values printed on our packaging are 210 to 250 kPa, 2.1 to 2.5 bar or 30 to 35 psi. Always follow the pressure specified by the vehicle manufacturer.
Why Does The Fitting Have To Be Tight
If the nozzle does not seal on the valve stem, air escapes at the joint and the gauge reads lower than the real tyre pressure.
How Do I Avoid Over Inflating
Use a preset digital model. Set the target pressure before you start and the pump stops automatically once the tyre reaches it.
What Else Can These Inflators Fill
With the three supplied nozzle adaptors they inflate cars, bicycles, motorcycles, sports equipment and inflatables.
Need This Guide In Your Own Packaging
We supply the instruction sheet artwork with your brand on it as part of an OEM programme.